Trigger modes not selectable

[SteveO]

I received my propscope today and down loaded propscope v1.04.

I can not select continuous or step modes.
The slide goes to the selected position for about two seconds then jumps back up to "off".

The scope is working. I'm monitoring a 9 volt square wave with a X10 probe.

My computer is a new acer running Windows7.

Any thoughts?

[SteveO]

I just discovered that the time base has to be 20 ms or above.

[Hanno]

Yup, the pre-1.06 of PropScope disable the trigger when in "datalogger" mode.
Hanno